01
Raised rails
Factory rails run front to back with a visible gap underneath. The bar feet clamp around the rails.
You can usually slide your fingers beneath the rail.
CRUZ Lane, Airo & Airo Dark available
The Egypt Fitment Guide العربية
The Ultimate Guide to Roof Bars and Roof Racks in Egypt
Identify your roof type, understand every component and choose the right CRUZ system for safer family travel across Egypt.
Correct fit
Matched to model, year and roof type
Quieter journeys
Aerodynamic profiles reduce wind noise
A secure foundation
For roof boxes and bicycle carriers
Start here
Rails or bars? Know the difference.
Factory roof rails run front to back. Roof bars—or crossbars—run side to side and form the load-bearing base for a roof box or bike carrier. “Roof rack” is often used for the complete system.
Do not buy from the vehicle name alone. Different trims of the same model can have different roof types.
02
Flush rails
Integrated rails sit directly against the roof with no open gap. They need a compatible, vehicle-specific foot kit.
The rail looks built into the roof and you cannot pass a hand underneath.
CRUZ system arriving soon
03
Fixed points
Threaded mounting points are hidden beneath small covers or flaps. Each vehicle needs the correct fitting kit.
Look for paired covers along the roof edge or inside the door frame.
CRUZ system arriving soon
04
Bare roof
There are no factory rails or visible mounting points. Protected clamp feet attach at the upper door frame.
The roof surface is plain from front to back.
CRUZ system arriving soon
The complete system
Three parts must work together
Crossbars
Steel or aerodynamic aluminium, in the correct width for the vehicle.
Foot pack
Connects the bars to raised, flush, fixed-point or bare roofs.
Vehicle fit kit
Model-specific brackets and pads where the roof design requires them.
| Roof type | How to identify it | How bars attach | CRUZ status |
|---|---|---|---|
| Raised rails | You can usually slide your fingers beneath the rail. | Factory rails run front to back with a visible gap underneath. The bar feet clamp around the rails. | CRUZ Lane, Airo & Airo Dark available |
| Flush rails | The rail looks built into the roof and you cannot pass a hand underneath. | Integrated rails sit directly against the roof with no open gap. They need a compatible, vehicle-specific foot kit. | CRUZ system arriving soon |
| Fixed points | Look for paired covers along the roof edge or inside the door frame. | Threaded mounting points are hidden beneath small covers or flaps. Each vehicle needs the correct fitting kit. | CRUZ system arriving soon |
| Bare roof | The roof surface is plain from front to back. | There are no factory rails or visible mounting points. Protected clamp feet attach at the upper door frame. | CRUZ system arriving soon |
Available now for raised rails
Choose your CRUZ system
Before the first journey
Your safety checklist
Check the vehicle handbook for its maximum permitted roof load.
Follow the lowest limit across the car, bars, roof box or carrier.
Distribute luggage evenly and secure it inside the roof box.
Confirm clearance for the tailgate, antenna and opening sunroof.
Recheck the feet after the first drive, then periodically and before long trips.
Know your total vehicle height before entering garages or low barriers.
Egyptian summer heat, long highways and vibration make periodic checks important. Inspect rubber pads, plastic covers and tightening before Sahel, Sokhna, Red Sea or Sinai trips.
Frequently asked questions
Before you choose
No guesswork needed
Send the make, model, year and two clear roof photos. We’ll identify your roof type and help match the right bars and feet.
Also read our Roof Box Buying Guide